Overview
Our Services
Repair Vs. Replace
Common Problems
Service Areas
Our Process
Why Choose Us
FAQs
Detail banner image
Entry door replacement in Dacula, GA.

Overview

Door Services in Dacula, GA

Your local Ace Handyman Services office handles door repair and installation for interior and entry doors in Dacula, GA. Our background-checked craftsmen fix sticking and sagging doors, reset hinges and strike plates, and hang new prehung or slab doors in homes across northeast Gwinnett, Braselton, and Hoschton. Appointments are scheduled for a specific time, the work is billed on time and materials, and the job site is cleaned up before we leave. Ace Handyman Services Dacula Braselton is America's Trusted Handyman serving Dacula, GA.

Our Services

Door Repair and Replacement Services for Homes in Dacula, GA

Most door calls start with a door that sticks, sags, or will not latch, and the right fix depends on what is actually wrong. We look at the hinges, the jamb, the strike plate, and the slab itself before deciding between door repair and door replacement. Whether it is a hall closet or the front entry, the four areas below cover most of what we are asked to do.

INTERIOR DOORS

Interior Door Installation and Repair

We hang prehung and slab interior doors, plane binding edges, and tighten loose hinges so bedroom, bath, and hall doors swing and latch cleanly.

  • Prehung door installation
  • Slab fitting and latch boring
  • Hinge and strike plate resets
  • Door painting and finishing
ENTRY DOORS

Exterior Entry Door Replacement

Entry door replacement means setting a new slab or prehung unit, checking the frame for rot, and adjusting the fit so the door closes square and seals well.

  • Prehung entry unit replacement
  • Frame and jamb condition checks
  • Deadbolt and handle set installation
  • Fit and swing adjustments
STORM & SLIDING

Storm, Sliding, and Closet Doors

We install storm doors, realign sliding patio and closet doors that jump their tracks, and replace worn rollers so they glide the way they should.

  • Storm door installation
  • Sliding door track and roller repair
  • Bifold and closet door alignment
  • Latch and closer adjustment
WEATHER SEALING

Weatherstripping and Thresholds

Worn seals and thresholds let in drafts, moisture, and insects, so we replace weatherstripping and set thresholds to meet the bottom of the door evenly.

  • Weatherstripping replacement
  • Threshold replacement
  • Door sweep installation
  • Gap and draft checks

Older doors that have been painted many times often bind because built-up paint has narrowed the gap at the jamb, so we strip and refinish the edges as part of door painting when that is the cause. If the frame is damaged or the wall around it needs work, we add trim carpentry and drywall patching so the finished opening looks right.

Our Full Range of Handyman Services

Appliances
Built-in Microwave Shelving
Washer & Dryer Setup
Clean Refrigerator Drip Pan & Condenser Coils
Install Window A/C Units
Bathroom
Replace Caulk, Grout & Tile
Install/Replace Shower Door
Hang Towel Racks, Mirrors & Accessories
Replace Mirror/Medicine Cabinet
Replace Subfloor
Carpentry
Build Shelving & Storage (Free-Standing or Built-In)
Repair or Replace Soffit Fascia
Molding: Crown, Base, Trim, Chair Rail & Exterior
Minor Framing Jobs
Install Wainscoting & Paneling
Masonry
Pour Concrete Pad or Steps
Powerwash/Crack Fill
Decks
Repair Steps
Repair Handrails
Powerwash & Seal/Paint
Repair or Replace Surface
Replace Joists
Build Covered Porch & Pergolas
Doors
Install Door Armor
Repair or Replace Doors
Weather Stripping/Adjust Operation
Replace Hardware
Refinish Stained Doors & Sidelights
Install Screen/Storm Doors
Drywall
Texture, Tape & Finish Drywall
Repair & Texture Drywall Holes
Add Walls & Closets
Flooring
Repair or Install Subfloor
Install Ceramic Tile, Slate, Wood & LVP
Replace, Upgrade, Repair, Paint & Stain Base Molding
Fence
Replace Posts
Repair Damaged Sections
Repair/Replace Gates
Gutters
Repair or Replace
Clean Out & Un-clog
Adjust/Add Downspouts for Proper Drainage
Handyman
Assemble/Move Furniture
Hang Pictures & Mirrors
Replace Hard-to-Reach Lightbulbs
Honey-Do Lists
Home Comfort & Efficiency
Install Insulation and/or Thermostat
Caulk Exterior Gaps
Insulate Crawl Space
Change Air Filters
Installation
Install Carbon Monoxide Detectors
Hook Up Stereo or Home Theater System
Replace Trim
Install Security System
Put Up & Take Down Holiday Lights
Seal Windows & Doors
Hang Flat Panel TV
Kitchen
Cabinet Hardware Upgrade
Install Countertops & Cabinet Doors
Add Backsplash
Repair Drawers
Refinish Cabinets
Caulk Countertops
Pets
Install Pet Door
Dog House Assembly
Catio Construction
Build Pet Enclosure/Dog Run
Safety
Child Proofing
Widen Doorways / Remove Trip Hazards
Install & Check Smoke & Carbon Monoxide Detectors
Senior Living Modifications
Install Hand Rails & Grab Bars
Install Special Fixtures: Knobs, Phone & Handles
Wheelchair Ramps / Widen Doorways
Non-Skid Flooring
Replace Door Knobs with Levers
Address Safety Concerns
Siding
Powerwash
Replace Trim
Install/Fix Shutters
Repair or Replace Wood, Vinyl, Composite, etc.
Storage
Build Storage Units & Closet Organizers
Install Attic Access Stairs
Replace Closet Doors
Tile
Remove & Replace Caulk and/or Grout
Floor Tile Repair or Replace
Install Tile in Bath, Kitchen, Foyer, etc.
Windows
Repair or Replace Windows / Eliminate Drafts
Install or Remove Screens or Storm Windows
Unstick & Wash Windows
Install Shutters & Hang Window Treatments
Winter
Ice Storm Damage Recovery
Winterize Vacant Homes/Businesses
Yard
Install Swing/Play Sets/Dog House
Check for Erosion/Bury Exposed Sprinkler or Wiring
Shed Assembly
Mow Lawn
Add Ground Cover
Paint
Interior Walls
Exterior Touch-Up
Sheds
Rooms
Repair Vs. Replace

Door Repair vs. Replacement

Situation Recommendation Rationale
Door sticks at the top corner in humid weather Repair Summer humidity swells wood doors, so planing the binding edge and sealing the bare wood usually restores clearance without needing a new slab.
Hinges loose with screws spinning in the jamb Repair Longer screws or glued wood plugs give the hinge fresh material to bite into, which fixes most sagging doors in a single visit.
Latch will not catch the strike plate Repair A misaligned strike plate or worn latch is a small adjustment, and resetting or replacing the hardware is faster than altering the door itself.
Sound door with a chipped, faded, or peeling finish Repair A solid door with a tired finish only needs sanding and fresh door painting and finishing to look new again, not a full swap.
Hollow-core door with a punched hole or crushed edge Replace Hollow-core skins cannot be patched well, so door replacement with a matching slab is the cleaner fix than building up layers of filler.
Entry door slab warped or delaminating Replace A warped slab will not seal against weatherstripping again, so a new slab or prehung unit is the dependable answer for entry doors.
Jamb rotted at the bottom where water collects Replace Rot spreads through a frame, so we cut out the damaged section or replace the frame and hang the door on sound wood.
Storm door frame bent or glass cracked Replace A bent frame never closes squarely again and cracked glass is a safety concern, so a new storm door is the sensible choice.
Common Problems

Why Doors Stick, Sag, and Fail

Heat, heavy summer thunderstorms, and a long spring pollen season all put stress on wood, paint, and hardware around doors in northeast Gwinnett. These are the six problems we are asked about most, along with how we approach each one. Most of them are fixable without replacing the whole door, which is why we diagnose before we recommend anything.

Door Sticks in Summer

Humidity swells wood doors until the edge rubs the jamb, and layers of old paint make the gap tighter. We plane the binding edge, seal the bare wood, and check the hinges so the problem does not return.

Sagging Door Rubbing the Frame

A heavy door pulls hinge screws loose over time, and the slab drops until it scrapes the latch side. We reset the hinges with longer screws, shim where needed, and confirm the gap is even all the way around.

Latch Misses the Strike Plate

When a door shifts, the latch no longer lines up with the strike plate and will not hold shut. We adjust or relocate the plate, chisel the mortise as needed, and test the latch until it closes with a light push.

Rotted Jamb or Door Bottom

Rain blowing against an entry and water pooling at the threshold soften the wood at the base of the frame. We cut out the damage, rebuild it, and add drywall patching and repair around the casing when the wall needs it.

Drafty Gaps Around Entry Doors

Worn weatherstripping and a threshold set too high or too low let drafts, pollen, and insects in around the edges. We replace the seals, adjust the threshold, and check that the door compresses the seal evenly.

Sliding Door Off Its Track

Dirty or worn rollers cause sliding and bifold doors to jam, jump the track, or drag on the floor. We clean or replace the rollers, straighten the track, and rehang the door so it glides without catching.

Service Areas

Local Areas We Serve

Our Process

Our Process

Every door job follows the same eight-step path, from the first conversation to the follow-up after the work is finished. The steps below show what to expect, and none of them ask you to make a decision before a craftsman has actually looked at the door.

01

Initial Contact

We respond quickly to your request and ask what the door is doing and what you want fixed.

02

Scheduling Your Appointment

We offer clear time options and confirm a specific appointment time, never a broad arrival window.

03

Job Preparation and Internal Handoff

Your project details are documented and shared with the assigned craftsman so the right tools and hardware arrive.

04

Pre-Visit Confirmation

Your craftsman contacts you the day before to confirm details, access to the door, and timing.

05

On-Time Arrival

Your craftsman arrives as scheduled and sends a text on the way to your home.

06

Professional Onsite Experience

Clear communication, respect for your home, and ongoing updates keep you informed while we work on your doors.

07

Completion and Walkthrough

We review the finished door with you, test the swing and latch, and answer any final questions.

08

Warranty Follow-Up

An 11-month follow-up call or email confirms your repaired or new door continues to meet expectations.

Why Choose Us

Why Homeowners Choose Our Door Service

Door problems rarely fix themselves. Our background-checked craftsmen are licensed, bonded, and insured, and we are a veteran-owned, locally operated office that is part of the Ace Hardware family. We keep a clean job site, stay honest about scope, and never upsell work a door does not need. Homeowners across northeast Gwinnett, Braselton, and Hoschton get the same careful approach on every visit.

Ace Handyman Services Dacula Braselton brings America's Trusted Handyman to homeowners in Dacula, GA. Schedule an Appointment Today to get a sticking, sagging, or damaged door working properly again.

FAQs

Frequently Asked Questions

Q: Can you replace an interior door without replacing the frame?

A: Yes, in most cases. If the frame is square, solid, and free of rot, we can swap in a new slab, cut the new hinge mortises to match, and bore for the latch. We replace the frame only when it is damaged, out of square, or no longer fits the new door size.

A: Wood absorbs moisture from humid summer air and swells, so edges that were fine in dry weather start rubbing the jamb. Heavy paint buildup narrows the gap even further. Planing the binding edge and sealing every face of the door, including the top and bottom, helps keep it from swelling again.

A: The cost of door repair depends on the scope of the work, the materials and hardware needed, how easy the door is to reach, and the condition we find when the craftsman looks at it. A hinge reset is a very different job from rebuilding a rotted jamb. Work is billed on time and materials, so the final cost follows what the door actually needs.

A: Yes. We install storm doors on entry doors across Dacula, Braselton, and Hoschton, including fitting the frame, setting the closer, and adjusting the latch so the door closes without slamming. If the main entry door needs work first, we can handle both during the same visit.

A: Either approach works. You can pick out your own door and we will handle door installation, or we can source one that fits your opening. Before anything is ordered, we confirm the size, swing direction, and whether you need a prehung unit or a slab so the door fits the first time.

A: Yes. Door painting is part of most installations, since a new slab should have every face and edge sealed and finished before it is hung. We also repaint existing doors that are chipped or faded, which is often all a sound door needs.

A: Repair is the right call when the slab and frame are solid and the problem is hardware, fit, or finish. Replacement makes sense for rot, warping, delamination, or a damaged hollow-core door. Heavy summer thunderstorms that drive rain against an entry can soften the bottom of a frame, so we check that area first.